Home > Suspension
Choose a sub category:
Control Arm Bushings
Sort By:
Page of 1
Torque Solution Adjustable Thrust Arm Bushing Kit: Porsche Torque Solution Camber Control Arms ( Dogbone ): Porsche 911 996/997 ALL
MSRP $225.00
MSRP $595.00
Porsche Adjustable Thrust Arm Bushing Kit
Torque Solution Adjustable Thrust Arm Bushing Kit
Applications: 996TT/GT2/GT3/C2/C4/C4S & GT3 Cup 997TT/GT2/GT3 & RS/C2/C4 and GT3 Cup
 
Torque Solution adjustable thrust arm bushing kit replaces the factory, rubber bushings on the wheel-end of the control arms with a billet aluminum bushing, this will allow for better handling and most important also allows for the adjustment of
caster.Replacement thrust arm bushings significantly improve the handling and response from your 996 or 997 suspension.

Can be used in all lower stock control arms as well as adjustable Porsche Motorsport Cup arms. Eliminates unwanted caster changes in both front and rear suspension under acceleration and deceleration. Helps minimize the soft feeling on the multilink factory suspension without major added in cabin road noise..  A great improvement for street cars and a must for anyone taking their car to the track. Your cars alignment on Factory equipment will change the 1st few laps around the track without solid thrust bushings to keep things in check.

Sold in kits of 4 to replace front or rear lower control arm bushings.

Fitment: 996TT/GT2/GT3/C2/C4/C4S & GT3 Cup
997TT/GT2/GT3 & RS/C2/C4 and GT3 Cup

 
Torque Solution Dogbone Rear Control Arms
Applications: 911 996/997 ALL


Torque Solution Rear Dogbone Kit is designed to correct the rear suspension geometry on your lowered Porsche 996/997. If you are experiencing uneven tire wear due to too much camber this kit will help bring your alignment back in spec for better performance and longer lasting tires. The factory camber adjustment range is not enough to bring your car back within spec after lowering the vehicle. if you plan to track your car or get the full life of your tires these are a must have..

Made of 6061-T6 Aluminum w/ Aurora Bearing Rod Ends.  4 links Total Included in Each Package Requires NO modification to chassis, direct bolt on replacement part. Can be used on daily driven street cars & is highly recommended for Street or Track setups..

Fitment: 996TT/GT2/GT3/C2/C4/C4S 997TT/GT2/GT3/GT3 RS/C2 /C4s


-Made out of lightweight 6061-T6 billet aluminum
-Street and track torture tested
-Black anodized / Torque Solution Laser engraved
-Aurora Bearing Rod Ends
-Lifetime Warranty
-Made in USA
   
 
certified secure site
We accept Mastercard, Visa, American Express, and Discover