Torque Solution adjustable thrust arm bushing kit replaces the factory, rubber bushings on the wheel-end of the control arms with a billet aluminum bushing, this will allow for better handling and most important also allows for the adjustment of
caster.Replacement thrust arm bushings significantly improve the handling and response from your 996 or 997 suspension.

Can be used in all lower stock control arms as well as adjustable Porsche Motorsport Cup arms. Eliminates unwanted caster changes in both front and rear suspension under acceleration and deceleration. Helps minimize the soft feeling on the multilink factory suspension without major added in cabin road noise..  A great improvement for street cars and a must for anyone taking their car to the track. Your cars alignment on Factory equipment will change the 1st few laps around the track without solid thrust bushings to keep things in check.

Sold in kits of 4 to replace front or rear lower control arm bushings.

Fitment: 996TT/GT2/GT3/C2/C4/C4S & GT3 Cup
997TT/GT2/GT3 & RS/C2/C4 and GT3 Cup

 

 

Torque Solution polyurethane filled Porsche transmission mounts are designed to limit the amount of transmission movement under on off throttle and braking conditions. The factory mount allows the transmission to move which gives the feeling of a sloppy drivetrain. The mounts will give the car a more direct feel and more precise driver input to the vehicle. You can expect a much better feel under Braking, Acceleration, & lateral G's. While typically most " Race Cars " use a SOLID MOUNT, this solution is less harsh and still maintains better control of the transmission movement without the issue of Solid Mount Vibration. Why replace your broken mount with the same rubber mount that will break again due to deteriorating rubber. Replace it 1x with a polyurethane filled mount and do it right.

*These are done with BRAND NEW mounts only.
 

- Eliminates wheel hop / traction loss
- Improved 60fts / e.t's
- BRAND NEW oem mount
- 75A durometer bushings
- Lifetime Warranty
- Made in USA

 

Torque Solution Porsche N1 Engine Mounts are designed to limit the amount of Engine movement from side to side which throws off the balance of the car under load. The factory mounts allow the engine to move which gives the feeling of a sloppy drivetrain. The mounts will give the car a more direct feel and more precise driver input to the vehicle. You can expect a much better feel under Braking, Acceleration, & lateral G's. While typically most " Race Cars " use a SOLID MOUNT, this solution is less harsh and still maintains better control of the engine movement without the issue of Solid Mount Vibration. The next issue with Solid mounts is the transmission of noise from the chassis to the knock sensor on the engine which can result in a tuning nightmare. These mounts will not affect knock sensor like solid mounts do.. 
 

- Eliminates wheel hop / traction loss
- Improved 60fts / e.t's
- Made out of lightweight 6061-T6 billet aluminum

- Black anodized / Torque Solution Laser engraved
- 75A durometer bushings
- Life Time Warranty
- Made in USA
 

 

 2 links Total Included in Each Package

Requires NO modification to chassis, direct bolt on replacement part.  Can be used on daily driven street cars & is highly recommended for Street or Track setups..

Lifetime Warranty